Basics ANETIC MILL

 ANETIC MILL

So in the previous blog (CHECK OUT HERE - the-new-way) we discussed how to generate energy, we also discussed the problem that comes with it..

And finally I am going to introduce the new method (Completely original)

THE ANETIC MILL.....

WHAT IS IT ?  

For starters Anetic mill uses magnet to generate electricity, usually mechanical energy is converted to kinetic energy which is then converted to electricity, but in case of Anetic mill magnetic energy is converted to kinetic energy and then to electricity...

So we take a ring on which one side (half the ring) is covered with magnets ranging from lowest to strongest.. like this...

                      

                                                    ( that's strongest instead of stronget )

Of course the design will be much more complicated but for the basic idea that's what is happening. Now we place a turbine with 3 fins made of pure iron in the middle and give it a little push towards the strongest magnet from bottom....

So that's the figure done but how does it work ?  I will discuss in detail in the next blog but here's the basics...

1. FIRST THE PUSH MAKES THE FIN GO TOWARDS THE MAGNET AND TOWARD THE STRONGEST ONE GRADUALLY ( THIS IS SPEED UP BY OTHER TWO FINS WHICH ARE FALLING DOWN DUE TO GRAVITY)

2. WHEN IT REACHES THE TOP, THE HEAVINESS OF THE FIN IS NOT WITHSTANDED BY THE STRONGEST MAGNET DUE TO GRAVITY..

3.SO ONE SPIN COMPLETES AND THEN AGAIN IT KEEPS ON GOING...

There are some issues in this but I will explain about how it can be avoided in the next blog.

IT WILL TAKE TIME FOR THE NEXT BLOG TO REACH OUT.. SO PLEASE BE PATIENT AND SHARE THIS BLOG AS MUCH AS POSSIBLE CUZ ITS THE ONLY CLEAN AND GREEN WAY TO PRODUCE CHEAP AND INEXPENSIVE ENERGY...